Override the Run Schedule (using the OVR button)

Full RT30 Installation Manual can be found here, this article references Step 14:

Instructions

  • The override function is designed for one-off events (cell cleaning, water flow checks,
    miscellaneous maintenance), allowing the unit to be turned on/off while leaving the
    system on “AUTO”.
    • The “AUTO” setting ensures that the scheduled cycles will run automatically, even if the unit is turned on/off via the override function.
    • The “ON” setting turns the unit on and it will remain on. The scheduled cycles will not
      run if the unit is set to “ON”.
    • The “OFF” setting turns the unit off and it will remain on. The scheduled cycles will not
      run if the unit is set to “OFF”.
  • To override while the system is set to “AUTO”:
    • Press the “OVR.” button.
    • If the system was running, it will turn off. If the unit was not running, it will turn on.

Note - always ensure your pool pump is running whenever the Chlorine Genie is ON, even if temporarily.

  • Resume the unit’s scheduled run cycles:
    • Press the “OVR.” button.
    • Locate the black Indicator Bar, it should still be above “AUTO”. If not, press “SELECT” to move the Indicator Bar to “AUTO”.

 

NOTE: If you forget to undo the override, the unit will still turn on/off per the configured
cycles if the system is still on “AUTO”.


EXAMPLE:
Cycle #1 is set to “ON” at 9 AM and “OFF” at 2 PM.
The “OVR.” button is pressed at 6 AM and the unit is turned on.
The unit skips the 9 AM ‘ON’ cycle but executes the 2 PM “OFF”.
The unit will run from 6 AM – 2 PM.

 

Time Clock